![]() ![]() There are a lot of Ansible options you can configure in your Vagrantfile. And finally, in step 4 we change the configuration of sshd, for not asking a password and restart our service. config.vm.provision shell, run: always, inline: ifconfig eth1 192.168.1.20 netmask. Notice the config.vm.provision section that refers to an Ansible playbook called playbook.yml in the same directory as the Vagrantfile.Vagrant runs the provisioner once the virtual machine has booted and is ready for SSH access. To see all of the arguments used, you can run vagrant ssh-config or vagrant ssh -debug for a more verbose output. In step number 3 we copy our id_rsa.pub into the Vagrant machine and rename as authorized_keys. The vagrant installation folder contains an ssh.exe that behaves like ssh(1) on linux (takes the same flags/arguments). In the next line ( 2) we specify the paths to the private keys to use to SSH into the guest machine. In line marked with 1 we tell to Vagrant that use Vagrant’s default insecure key inside the machine. You can instruct Vagrant to use the same SSH key for each VM. Sudo sed -i -e "\\#PasswordAuthentication yes# s#PasswordAuthentication yes#PasswordAuthentication no#g" /etc/ssh/sshd_config Vagrant generates a unique SSH key on the host for communication with each virtual machine. config.vm. Config.vm.network "public_network", bridge: "en0: Wi-Fi (AirPort)", auto_config: falseĬonfig.vm.provision "shell", run: "always", inline: "ip addr add 192.168.15.200 dev eth1"Ĭ_key_path = # 2Ĭonfig.vm.provision "file", source: "~/.ssh/id_rsa.pub", destination: "~/.ssh/authorized_keys" # 3 # 4Ĭonfig.vm.provision "shell", inline: <<-EOC The above command will display all the ssh details like username, key file location etc as shown below. ![]()
0 Comments
Leave a Reply. |